SDVC34MRJ help you to feed parts whose quentity that you expect

 Introduction

In the process of the Automated manufacturing, the feeding parts quantity need to be control. Our product SDVC34 series can solve this problem. When the quantity of the feeding parts arrive the setting quantity in the controller, the power output will be stopped. In some situation, the feeder bowl feed the parts quickly and for counting the parts accurately, when approximate the quantity expected , the feeding speed will slow down until arriving the quantity that you set.

Ready

1. SDVC34MRJ

2. PNP/NPN  proximity sensor (you could use other NPN/PNP sensor.)

Wiring method of counter

• NPN Wiring method

Operation

1. Long press the Function Button and Up Button to enter the adjusting parameter interface.

Fig.1 Enter to the parameter adjusting interface

2. Short press Function Button continuouslly for switching to the parameter Tc. 

Fig.2  Switch to the parameter Tc

3.Short Press the Up Button to start the counter.

Fig.3 Start the counter by short press the Up button 

4.Switch to the J parameter (The maximum number of counter which you expect ) by Short press the Function Button one time and increase the value of the parameter by short press the 🔺 button (decrease the value by short press the 🔻 button).

Fig.4 Adjust the value of the expected count number 

 5.Use the proximity sensor to count the material. when the count number reaches 10, the vibrator is stop and the stop indicator lights up. 

 Fig.5 use the proximity sensor to count the material

  6.Reset the counter of the controller by short press the 🔺 or 🔻 button.

  7.Reset the counter of the controller by short the reset port  and GND port.

 

Note

1. Never hesitate contact CUH with any questions about feeder controller or automation.
2. If you have any technical problem, please contact us.
3. Email: mz@cuhnj.com
4. Tel : 86-25-84730416
5. Fax: 86-25-84730426